Foxconn updating escd
Foxconn updating escd - Xxxvideo cam 3g
I then wired this to the ribbon cable and hooked the power connector into another running machine. HOWTO: Supplies: To make the cable I used a DB25M TO IDC10 SERIAL connector. They look like this: The header is found on the motherboard directly to the left of the south bridge.
It wiped it clean, loaded the new one, and then it couldn't verify.
I made a really bad attempt at using a chopped up parallel cable and the ends from a USB header port thing.
This didn't work out well so I found at the local electronics store a parallel connector with a ribbon cable on it.
I took it apart and re-soldered the ribbon to the correct pins.
To get the ~3V, I took a pass through power connector from an old case fan and added three diodes to the 5V wire, giving me a little over 3V.
It was able to erase the BIOS without problems, but failed to write the new BIOS.
i knew that when i next rebooted the computer: it would be a brick. But before i rebooted i transferred the bios backup, the new bios, and Asus DOS-based flash utility to another computer. This Asus motherboard has a fail-safe bios recovery called WARNING: Never use the ASUS Windows based bios flash utility.
Stack Exchange network consists of 172 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.
Visit Stack Exchange doesn't fully support Windows 64-bit.
Having no other choice I rebooted the machine and hoped for the best. It was time to send it back to ASUS so they could reflash it.
The bios isn't removable, so surely there's some kind of device they plug into to reflash it for you I thought. Next to the BIOS chip, to the left of the south bridge, is an undocumented 7 pin connector labeled SPI_J1.
If you've tried the above recommendations and your computer continues to freeze at the DMI message, it may be a sign that one of your hardware components is malfunctioning.